Ariens 915175 Operator's Manual page 26

Figure 22
2. Reinstall idler arm and belt fingers. See
Figure 21.
3. Reinstall belt covers and secure each
with three self-tapping screws removed
earlier.
4. Reinstall mower deck. See Install Deck
on page 29.
IMPORTANT: Make sure belt has tension and
remains aligned after installation is complete.
Remove Ground Drive Belt
IMPORTANT: Retain all parts for
reinstallation.
1. Remove mower deck. See Remove Deck
on page 28.
2. Tip seat forward.
3. Loosen nut on eye bolt and disconnect
idler arm spring. See Figure 23.
6.1 cm
(2.4")
1. Nut
2. Eye Bolt
3. Idler Arm Spring
4. Remove the right-side self-tapping screw
from heat shield and rotate shield out of
the way.
5. Remove two self-tapping screws from
clutch stop bracket and remove bracket.
See Figure 24.
1
1. Heat Shield
2. Clutch Stop Bracket
3. Self-tapping Screw
EN - 24
3
1
2
Figure 23
2
Figure 24
3