Fujitsu LifeBook C6659 Manual page 66

Opening the LCD display
Use this method if you placed the computer into standby mode by closing the LCD display.
1. Make sure that the
2. Open the LCD display.
Unlock the LCD display by sliding the latch on the front panel to the right, and lift the display while
holding the computer with a hand.
After a while, the system will resume at the same point as when you suspended operation.
Latch
Status indicator LCD
(The illustration varies depending on the model and use conditions.)
Resume by receiving an incoming call
Some communication applications allow the computer to automatically resume operation when the
internal model receives an incoming call. To make this possible, you need to keep the communication
program active during standby.
Caution about the standby mode
• Don't turn the MAIN switch off during standby, or all data being processed will be lost.
• When the computer is powered from a fully-charged new battery, it can be kept on standby for
about 1 day.
• During standby, the computer consumes a small amount of power to keep data in the system
RAM. If power is supplied by the internal battery, pay attention to the remaining battery life. If the
battery goes dead during standby, all data being processed will be lost. If you know you will not
use the computer for a prolonged period of time, don't put the computer into standby mode, but
save all data, shut down Windows and turn off the computer.
• When the computer resumes operation as a result of the reception of a incoming call, it will
display nothing on the screen. To turn on the display, touch the Flat Point (move the mouse). If
this does not turn on the display, press the @ key or any other key. If this operation does not still
restore the display, check whether the
the computer is still on standby. In this case press the SUS/RES switch to resume operation.
• When power is supplied by the internal battery, the time for which your computer can be kept on
standby may be shortened, depending on the PC card installed.
• If you placed the computer into standby mode, using the Shut Down Windows dialog box or the
SUS/RES switch, opening the LCD display does not cause the computer to resume operation.
48
icon is blinking on the CoolView Panel.
LCD display
icon is blinking on the CoolView Panel. If it is blinking,