Programming The High And Low Limits And Range Of The 7Th Column Of Bars - Electronics International UBG-16 Operating Instructions Manual

7. 7. 7. 7. 7. To exit this programming mode, push and hold the Mode Switch to the left until the word "END"
appears in the digital display.
Programming the High and Low Limits and Range of the 7th Col- Programming the High and Low Limits and Range of the 7th Col- Programming the High and Low Limits and Range of the 7th Col-
Programming the High and Low Limits and Range of the 7th Col- Programming the High and Low Limits and Range of the 7th Col-
umn of Bars: umn of Bars: umn of Bars:
umn of Bars: umn of Bars:
The 7th column of bars may be used to display EGT and CHT on a 7-cylinder engine, TIT or Oil Temperature, or
it may be turned off. A High and Low Limit may be programmed for whatever temperature is displayed on the
7th column of bars.
If the 7th column is used to display TIT or Oil Temperature, the range of the 7th column of bars may be custom-
ized to accommodate any temperature, engine or pilot preference. This is done by programming the temperatures
at which the Upper and Lower Bars come on (Trip Points).
If the 7th column is used to display EGT and CHT for a 7 cylinder engine, see "Programming the High and Low
EGT and CHT Limits" above. Otherwise, when operating in the Normal Mode only
1. 1. 1. 1. 1. Select the 7th column using the Step Switch.
2. 2. 2. 2. 2. Press and hold the mode switch to the left until the word "PROGRAM" appears in the digital display.
Release the Mode Switch and "SET H" will appear on the left side of the UBG display. Also, "TIT" or
"OIL.T" will appear in the left portion of the digital display and the right portion will show the current
Height Limit. The digit to the far left will be blinking.
3. 3. 3. 3. 3. Use the Step Switch to increase or decrease the digit that is
blinking. The High and Low Limits and Trip Points can be set
from 0 to 1990'F in 10'F increments.
4. 4. 4. 4. 4. Use the Mode Switch to blink a specific digit.
5. 5. 5. 5. 5. To change functions, push the Mode Switch to the right (or left)
until the digital display shows the function you wish to program.
The functions will appear in the following order:
A. A. A. A. A. "TIT" or "OIL.T", High Limit.
B. B. B. B. B. "TIT" or "OIL.T", Low Limit.
C. C. C. C. C. Upper Bar Trip Point.
D. D. D. D. D. Lower Bar Trip Point.
Normal Mode only, perform the following steps: Normal Mode only Normal Mode only
Normal Mode only
15