Installation - Water Supply - Heatrae Sadia Supreme 150SS Fitting Instructions And User Manual

4.0 INSTALLATION - WATER SUPPLY

4.1 Select appropriate push fit connector for chosen entry position:
B o t t o m e n t r y w a t e r - 1 5 m m x 1 5 m m 9 0 ° e l b o w .
R e a r e n t r y
NOTE: stainless or chromed pipes DO NOT provide secure
connections with push fit fittings (use copper pipe at joints).
4.2 Push the connector fully home (28mm engagement) onto the
solenoid valve inlet spigot. To remove a push fit connector the collar
(collet) should be pushed towards the body of the fitting whilst pulling
the connector off the pipe.
4.3 If the inlet pipe run is horizontal and beneath the unit ensure it does
not prevent access to the case screws.
4.4 Connect the inlet pipe to the push fit connector ensuring it is fully
pushed home (28mm engagement). After connection DO NOT make
soldered joints in the pipework close to the heater, as the heat may
damage the connector or the water heater itself.
4.5 A WRAS listed isolating valve should be fitted to the cold supply to
facilitate servicing the heater.
4.6 Push fit connectors are supplied to allow either bottom or
rear entry of services. If a combination of entry points are
required an additional connector will be required as follows:
Bottom inlet, rear vent 15mm x 15mm elbow (part no. 95 607 510)
Rear inlet, bottom vent 15mm x 15mm straight (part no. 95 607 509)
w a t e r - 1 5 m m x 1 5 m m s t r a i g h t .
7