Mounting The Transducer - Raymarine axiom 7 Installation Instructions Manual

Mounting the transducer

The transducer must be mounted on the transom using the mounting bracket provided. The steps
below describe the initial mounting steps required in order to test your transducer's performance.
After testing the transducer you must finish the mounting following the instructions in the
the transducer mounting
Note: Before starting this procedure, check that the plastic chock (marked 'A' in the illustration)
is already positioned in front of the transducer cable. If it is not, push the chock into the correct
position, aligning the hole in the chock with the holes in the transducer hanger.
1. Position the transducer hanger between the mounting bracket arms, ensuring that the transducer
cable is routed between the arms, and the center hole is aligned with the holes in the arms.
2. Slide the flanged mounting bolt through the mounting bracket assembly.
3. Screw the flanged nyloc nut onto the end of the mounting bolt, and hand-tighten.
4. Using a pair of 14 mm wrenches, tighten the nut onto the mounting bolt until the transducer
hanger stays in position, but can still be adjusted by hand.
10
section.
Finishing