Wimax Configuration - ZyXEL Communications MAX-207HW2R User Manual

Table 23 ADVANCED > WAN Configuration > Internet Connection > ISP
Parameters for Internet Access (continued)
LABEL
Auth Mode
Certificate
WAN IP Address Assignment
Get
automatically
from ISP
(Default)
Use Fixed IP
Address
IP Subnet Mask
Gateway IP
Address
Apply
Reset

7.3 WiMAX Configuration

Click ADVANCED > WAN Configuration > WiMAX Configuration to set up the
frequencies used by your MAX-207HW2R.
In a WiMAX network, a mobile or subscriber station must use a radio frequency
supported by the base station to communicate. When the MAX-207HW2R looks for
a connection to a base station, it can search a range of frequencies.
MAX-207HW2R User's Guide
DESCRIPTION
Select the authentication mode from the drop-down list box.
This field is not available in all MAX-207HW2Rs. Check with your
service provider for details.
The MAX-207HW2R supports the following authentication modes:
• User Only
• Device Only with Cert
• Certs and User Authentication
This is the security certificate the MAX-207HW2R uses to
authenticate the AAA server. Use the TOOLS > Certificate >
Trusted CAs screen to import certificates to the MAX-207HW2R.
Select this if you have a dynamic IP address. A dynamic IP address
is not fixed; the ISP assigns you a different one each time you
connect to the Internet.
A static IP address is a fixed IP that your ISP gives you. Type your
ISP assigned IP address in the IP Address field below.
Enter a subnet mask in dotted decimal notation.
Refer to the appendices to calculate a subnet mask If you are
implementing subnetting.
Specify a gateway IP address (supplied by your ISP).
Click to save your changes.
Click to restore your previously saved settings.
Chapter 7 The WAN Configuration Screens
75