Before Cooking Rice - Tiger JAX-S10W Operating Instructions Manual

3

Before Cooking Rice

1
Measure the rice.
Always use the measuring cup supplied with
the rice cooker (for rinse-free rice as well).
A level filling of rice in the supplied measuring
cup equals about 0.18 L.
● Fill the measuring cup as shown below.
Correct Incorrect
measurement measurement
Note
● Always use the specified volume of rice (see
"Specifications" on p.43). Otherwise the rice
may not cook properly.
If other ingredients are to be added to the rice,
see p.12.
2
Wash the rice. (This can be
done using the inner pot.)
For rinse-free rice, see p.12.
Note
● Do not use hot water (over 35°C) to wash the
rice or when adding water. It may prevent the rice
from cooking properly.
● Do not apply too much force while washing the
rice.
This could damage the inner pot and prevent rice
from cooking properly.
14 14
3
Adjust the water level.
Place the inner pot on a level surface and
adjust the water level to the appropriate line
of the corresponding scale on the inside of
the pot.
● The water level should be selected according
to the type of rice and the selected cooking
menu, but can be fine-adjusted to your personal
preference. (See the guidelines on p.12.)
When cooking 3 cups
of white rice, adjust the
water level to line "3"
on the "Plain" scale.
4
Wipe off any water and rice, etc.
<Outer surface and brim of the inner pot>
<Inside the rice cooker>
Lid gasket
Inner lid
Heating plate
Inside the
Upper casing
rice cooker
Center
Hook
sensor
button
Caution
● Be sure to remove any rice or other material adhering
to and around the heater plate, center sensor, upper
casing, and the hook button. (See p.31.)
Adhering material can prevent the lid from
closing, allow steam to leak out during cooking, or
enable the lid to open and the contents to spray
out, resulting in burns or other injury.
5
Place the inner pot in the rice
cooker.
(1) Turn the inner pot slightly left and right so
it is positioned correctly without any tilt.
(2) Close the lid.
(2) Close lid.
Inner pot
Inner lid
(1) Set pot inside rice
cooker.
Note
● Make sure the inner pot is set securely into the
rice cooker.
● Be careful not to touch an operation key when
closing the lid.
6
Connect each end of the power
cord to the specified locations.
(1) Connect
Appliance plug
(2) Connect
Power plug
The power will turn on and the symbol will
blink.
Blinks
Note
● If the Keep Warm lamp is on, press the
[KeepWarm/Cancel] key to turn off the lamp.
On Off
15 15