AOC LE32S5970 User Manual page 53

Channel list version
Check the current version of the channel list...
1 - Press the Settings key, select General settings > Channel
List Copy and press OK.
2 - Select Current version, then press OK.
3 - Press  (left) repeatedly if necessary, to close the menu.
Upload a channel list
To TVs that are not installed
Depending on whether your TV is already installed or not, you
must use a different method to upload a channel list.
To a TV that is not yet installed
1 - Plug in the power plug to start the installation and select
language and country. You can skip the channel search. Finish the
installation.
2 - Plug in the USB flash drive that holds the channel list of the
other TV.
3 - To start the channel list upload, press the Settings key,
select General settings and press OK.
4 - Select Channel List Copy > Copy to TV and press OK.
Enter your PIN code if necessary.
5 - The TV notifies you if the channel list is copied to the TV
successfully. Unplug the USB flash drive.
To installed TVs
Depending on whether your TV is already installed or not, you
must use a different method to upload a channel list.
To an already installed TV
1 - Verify the country setting of the TV. (To verify this setting,
see chapter Reinstall All Channels. Start this procedure until you
reach the country setting. Press  BACK to cancel the
installation.)
If the country is correct continue with step 2.
If the country is not correct, you will need to start a
reinstallation. See chapter Reinstall All Channels and start the
installation. Select the correct country and skip the channels
search. Finish the installation. When done, continue with step 2.
2 - Plug in the USB flash drive that holds the channel list of the
other TV.
3 - To start the channel list upload, press the Settings key,
select General settings and press OK.
4 - Select Channel List Copy > Copy to TV and press OK.
Enter your PIN code if necessary.
5 - The TV notifies you if the channel list is copied to the TV
successfully. Unplug the USB flash drive.
Install digital channels
If you know the channel frequency of the channels you want to
install, you can search and store digital channels one by one. For
best results, contact the service provider.
1 - Press the Settings key, select Antenna/cable installation and
press OK.
2 - Enter your PIN code if necessary.
3 - Select Digital: Reception test > Search and press OK.
4 - Press the numbered buttons to enter the channel frequency.
5 - Select Search and press OK.
6 - When the channel is found, select Store and press OK.
53