Network Settings - AOC LE32S5970 User Manual

• If the connection fails, you can check the DHCP (Dynamic
Host Configuration Protocol) setting of the router. DHCP
should be switched on.
Wired connection
What you need
To connect the TV to the Internet, you need a network router
with an internet connection.
Use a high-speed (broadband) Internet connection.
Make the connection
To make a wired connection...
1 - Connect the router to the TV with a network cable
(Ethernet cable**).
2 - Make sure that the router is turned on.
3 - Press the Settings key, select Network and press  (right) to
enter the menu.
4 - Select Connect to network and press OK.
5 - Select Wired and press OK. The TV constantly searches for
the network connection.
6 - A message will be shown when the connection is successful.
If the connection fails, you can check the DHCP setting of the
router. DHCP should be switched on.
**To fulfill EMC regulations, use a shielded FTP Cat. 5E Ethernet
cable.

Network settings

View network settings
You can view all current network settings here. The IP and
MAC address, signal strength, speed, encryption method, etc.
To view the current network settings...
1 - Press the Settings key, select Network and press  (right) to
enter the menu.
2 - Select View network settings and press OK.
3 - Select Next to view the current network settings, or select
Close to close the menu.
Network configuration
If you are an advanced user and want to install your network
with Static IP addressing, set the TV to Static IP.
To set the TV to Static IP...
1 - Press the Settings key, select Network and press  (right) to
enter the menu.
2 - Select Network configuration and press OK.
3 - Select Static IP and press OK to enable Static IP
configuration.
4 - Select Static IP configuration and configure the connection.
5 - You can set the number for IP
address, Netmask, Gateway, DNS 1, or DNS 2.
6 - Press  (left) repeatedly if necessary, to close the menu.
Switch On with Wi-Fi (WoWLAN)
You can switch this TV on from your smartphone or tablet if the
TV is on Standby. The setting Switch On with Wi-Fi
(WoWLAN) must be switched on.
To switch on WoWLAN...
1 - Press the Settings key, select Network and press  (right) to
enter the menu.
2 - Select Switch on with Wi-Fi (WoWLAN) and press OK.
3 - Select On and press OK.
4 - Press  (left) repeatedly if necessary, to close the menu.
Digital Media Renderer - DMR
If your media files do not play on your TV, make sure that the
Digital Media Renderer is turned on. As a factory setting, DMR is
turned on.
To switch on DMR...
1 - Press the Settings key, select Network and press  (right) to
enter the menu.
2 - Select Digital Media Renderer - DMR and press OK.
3 - Select On and press OK.
4 - Press  (left) repeatedly if necessary, to close the menu.
Switch on Wi-Fi connection
You can switch the Wi-Fi connection on your TV on or off.
To switch on Wi-Fi...
1 - Press the Settings key, select Network and press  (right) to
enter the menu.
2 - Select Wi-Fi On/Off and press OK.
3 - Select On and press OK.
4 - Press  (left) repeatedly if necessary, to close the menu.
TV network name
If you have more than one TV in your home network, you can
give the TV a unique name.
To change the TV name...
1 - Press the Settings key, select Network and press  (right) to
enter the menu.
2 - Select TV network name and press OK.
3 - Enter the name with the on-screen keyboard.
20