Switching Off The Appliance - Bosch SHEM78WH5N Operating Instructions Manual

en-us Operating the Dishwasher
Tone volume
The end of the wash cycle is
indicated by a buzzer. You can also
change this setting.
Button volume
When you are operating the
dishwasher, a signal sounds
whenever a button is pressed. You
can control the volume of the signal.
If you do not like the button volume,
you can switch it off.
Greeting
When you switch on the dishwasher,
the brand logo appears. You can
switch off the brand logo.
Factory setting
You can reset all settings to the
factory setting.
Switching the appliance on
Turn the water supply on fully.
1.
Open the door.
2.
Switch on On/Off switch (.
3.
The AUTO 130 - 150° F wash
cycle has been preset as a
default whenever the appliance
starts. This wash cycle remains
selected if no other wash cycle
button 0 is pressed.
Press Start button )*.
4.
Close the door.
5.
Wash cycle sequence starts.
Your dishwasher is protected
Note:
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Press the Start button again
and close the appliance door.
38
Delay start time
You can delay the start of the wash
cycle by up to 24 hours. Depending
on the setting of the time display, the
end of cycle is indicated with "Finish
in" (for example 3h 25m) or "Finish
at" (for example 15:20 hours).
Open the door.
1.
Switch on On/Off switch (.
2.
Select wash cycle 0.
3.
Press Delay start button `.
4.
Keep pressing the setting buttons
5.
+ - X until the displayed time
corresponds with your
requirements.
Press Start button )*, timer
6.
programming is activated.
To delete the Delay start time,
7.
press Start button )* for about
3 seconds.
Close the door.
8.
Your dishwasher is protected
Note:
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Press the Start button again
and close the appliance door.
Wash cycle end
The wash cycle has ended when
"Finished" is indicated on the digital
display @.

Switching off the appliance

Short time after the end of the wash
cycle:
Press On/Off button (.
1.
Turn off water supply.
2.
Remove the utensils when they
3.
have cooled down.