Flex Shadow Settings - Sony DVS-9000 User Manual

Flex Shadow Settings

Notes
• The Flex Shadow function is not supported on the MVE-8000A.
• "Mix Color" or "Ext Video"can only be applied to one of the background
• When executing combining four channels of DME images, "Mix Color" and
Applying a flex shadow
1
2
3
548
DME Special Effect Operations
(see page 636), flex shadow, trail (see page 611), and wind (see page 619)
effects.
If you select "Mix Color" or "Ext Video" in one of these settings, a selection
of "Mix Color" or "Ext Video" in any of the other effects is disabled, and
"Flat Color" is selected in its place.
"Ext Video" in the flex shadow and background effects cannot be selected.
In the DME menu, select VF1 'Edge' and HF5 'Flex Drop Shadow.'
The Flex Shadow menu appears.
Press [Flex Shadow], turning it on.
This enables flex shadows, and you can now use the knobs to adjust the
parameters.
Note
The Flex shadow function cannot be enabled when the following functions
are enabled.
• Any nonlinear effect
• Brick
• Shadow
Adjust the following parameters.
The valid ranges of the parameter values depend on the aspect ratio (4:3/
16:9) selected in the system, as follows.
• 4:3 mode
Knob Parameter
1 H
2 V
3 Size All
4 a)
Soft
Adjustment
Move shadow horizontally
Move shadow vertically
Enlarge or shrink horizontally and
vertically
Softness of shadow
Setting values
–8.00 to +8.00
–6.00 to +6.00
Value of Size H (see
page 550) shown
0.00 to 100.00