Sony DVS-9000 User Manual page 225

When the edge type is outline, in place of the edge fill signal, the selected
key fill signal fills the outline, and elsewhere remains as the background.
5
Carry out the following operation, depending on the selection in step 4.
When [Utility 1 Bus] is selected: Hold down the [UTIL] button in the
cross-point control block, and select the signal in the background A
bus row.
While the [UTIL] button is held down, the background A bus changes
to the utility 1 bus.
Note
To enable the [UTIL] button, its operation mode must be set to [Hold]
beforehand. (See "Operation Settings (Operation Menu)" in Chapter
19 (Volume 3).)
When [Matte] is selected: Press [Matte Adjust] in the same EDGE menu,
to display the Matte Adjust menu, and adjust a single color or two-
color combination color matte.
You can select whether to use a single color matte or a two-color
combination color matte in the <Edge Matte> group.
For the color mix operation, see "Carrying out a color mix for the key edge
fill matte" (page 226).
6
When emboss is selected for the edge type, adjust the color in the <Emboss
Fill> group.
To adjust matte 1 press [Matte1], and to adjust matte 2 press [Matte2], then
adjust the following parameters.
Knob Parameter
1 Luminance
2 Saturation
3 Hue
7
To make the edge soft, press [Soft Edge] to set it on, and adjust the
softness.
Knob Parameter
1 Soft
For a normal edge, when [Soft Edge] is enabled, [Key Drop] is kept on.
Adjustment
Luminance
Saturation
Hue
Adjustment
Edge softness
Key Setting Operations Using Menus
Setting values
0.00 to 100.00
0.00 to 100.00
359.99 to 0.00
Setting values
0.00 to 100.00
225