Accessories - Max ER-1600 Instruction Manual

The data stored in the internal memory or the memory card cannot be stored perma-
nently. We will not be responsible for damages and lost profits caused by loss of data
attributed to battery consumption, trouble, repair, and so on.
Never disassemble or modify this instrument. It could cause a fire, electric shock, or
other problems.
Do not insert foreign substances such as fingers, pens, wire, or paper into this in-
strument. It could damage the instrument or cause a fire.
Use correct supply voltage. Other voltage level could damage the instrument.
Do not splash water or chemicals on the instrument. If water gets inside the in-
strument, disconnect the power plug immediately from the plug socket and contact
your dealer/distributor for a repair. It could damage the instrument or cause a fire
or electric shock.
Do not put paper or cloth on the instrument. It could cause a fire.
Do not place any heavy material on power cord. It could cause damage or a fire.
Never touch the printer head. It is very hot just after printing and you could get
burned. Also, dirt on your hand could cause trouble to the printer head.
When the instrument is not going to be operated for a long period of time, be sure to
disconnect the power cord from the power socket for your safety.
When disconnecting the power cord, be sure to hold the power plug. Do not pull on
power cord, or the cord could be broken and cause a fire or electric shock.

ACCESSORIES

This instrument comes with the following accessories. Confirm that they are included before
using the machine.
1. Instruction manual
: 1 booklet
CAUTION
2. Screws for wall mounting
: 2-pcs.
- 3 -
Do not drop or hit the instrument.
Install this instrument away from the following places:
1. Any place that is not level or that is subject to vibration.
2. Any place that has dust or high humidity. Keep beverages and
liquid containers away from this instrument.
3. Any place that the temperature goes below 0
40 /104 .
4. Any place that catches direct sunlight or is located close to a
heat source.
Do not insert cards or paper other than the specified time cards for
this instrument. Do not use time cards that are bent or torn.
Be sure to use a dry cloth for cleaning. Do not use solvents (al-
cohol, benzene, thinner, etc.) or a damp cloth.
Do not re-ink cartridge. Replace with ink ribbon cassette
ER-IR103.
Do not hang this instrument on a wall using anything other than the included plate for wall
mounting.
The socket-outlet shall be installed near the equipment and shall be easily accessible.
A 30-minute break is required after continuous printing for 15 minutes.
/32 or over
- 4 -