Functions; Partial Scan; Binning - Sony XCG-C30 Technical Manual

Functions

Partial Scan

Only the area selected from the effective pixel area can
be read out. Clearing unnecessary parts at high-speed
allows high-speed reading. The area size is selected by
the Height and Width registers, and the read beginning
point is selected by the OffsetX and OffsetY registers.
Reducing Height increases the frame rate, but changing
the Width register does not change the frame rate. Partial
scan can be set with or without a trigger. Binning can be
used at the same time.
OffsetX and OffsetY relate to Width and Height as
follows:
OffsetX + Width ≤ Width (maximum value)
OffsetY + Height ≤ Height (maximum value)
Notes
• Since the shutter setting has priority, use a shutter
speed high enough to enable partial scan at a higher
frame rate.
• When the power is supplied by PoE, you cannot set the
Height setting to a setting lower than the standard
setting.
Configurable range
XCG-C30/C 16 to 640 to 658
XCG-C32/C
16 to 640 to 658
XCG-C130/C
16 to 1280 to 1296 32 to 960 to 966
Configurable values
The values of OFFSETX, OFFSETY, WIDTH and
HEIGHT increase or decrease in steps of 2.
16
Partial Scan
Width Height
32 to 480 to 494
32 to 480 to 494

Binning

By adding 2 vertical pixels or 2 horizontal pixels, the
frame rate in vertical binning is increased along with the
sensitivity. The color camera cannot set this. This can be
set with or without a trigger. Partial scan can be used
concurrently and horizontal and vertical can be set at the
same time.
Register Parameter
BinningVertical 1
2
BinningHorizontal 1
2
Notes
• The binning function is disabled when the power is
supplied by PoE.
• Use a shutter speed high enough to enable binning at
a higher frame rate.
Partial scan
Setting
No vertical binning
Vertical binning
No horizontal binning
Horizontal binning