Table of Contents
Advertisement
Rear
e RJ45 connector
You can connect a LAN cable to this connector to
control the camera module from a host device to output
image to a host device. By using a PoE-compatible LAN
cable and camera module interface board or hub, you
can supply power using the LAN cable.
(Refer to Fig.
above for the pin assignment of the
5
connector.)
Pin No.
Signal
1
TP3 +
2
TP3 –
3
TP2 +
4
TP1 +
Note
For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
f DC IN (DC power input) connector (6-pin)
You can connect a camera cable to input the +12 V DC
power supply. The pin configuration of this connector is
as follows.
(Refer to Fig.
above for the pin assignment of the
6
connector.)
Pin No.
Signal
1
DC input (10.5 V
to 15 V)
2
GPI1 (ISO +)
3
GPI2/GPO2
8
Location and Function of Parts and Operation
Pin No.
Signal
5
TP1 –
6
TP2 –
7
TP4 +
8
TP4 –
Pin No.
Signal
4
GPI3/GPO3
5
GPI1 (ISO –)
6
GND
g Reset switch
This reformats the network settings.
h Status LED (Green)
When power is on, this LED lights up.
Advertisement
Table of Contents
