Replacing Hydrostatic Belt - Ariens 915213 – Zoom 42 Operator's Manual

Models 915209, 915211
1
2
1. Deck Spindle
2. Engine Drive Pulley
3. Deck Idler
4. PTO Belt
Figure 25
Models 915213, 915215, 915233, 915235
4
1
1. Deck Spindle
2. Engine Drive Pulley
3. Deck Idler
4. PTO Belt
Figure 26
3
1
4
2
1
3
Install
(Figure 25)
NOTE: Do not install PTO belt on left mower
deck pulley in step 1.
1. Install PTO belt on engine drive pulley
and mower deck.
2. Rotate idler arm clockwise until PTO belt
can be routed around left mower deck
pulley.
3. Slowly release idler arm until idler pulley
rests firmly against PTO belt.
4. Install belt covers on mower deck.
NOTICE: Ensure that belt is still positioned in
the groove of the sheaves after belt covers
are installed.
REPLACING HYDROSTATIC
BELT
Remove
(Figure 27)
1. Remove PTO belt. See Replacing PTO
Belt on page 30.
CAUTION: Use care when
releasing idler spring tension.
Keep body parts well away from
idler when performing this
operation.
2. Disconnect idler spring.
3. Remove hydrostatic belt from
hydrostatic transmission pulleys, drive
pulley, and idler.
Install
(Figure 27)
1. Install hydrostatic belt on idler, drive
pulley, and hydrostatic transmission
pulleys.
2. Connect idler spring.
3. Install PTO belt. See Replacing PTO
Belt on page 30.
EN - 31