Replacing Hydrostatic Belt - Ariens Gravely 915 ZT EZT Service Manual

7.4 REPLACING HYDROSTATIC BELT

Remove (Figure 22)
1
2
7
6
1. Hydrostatic Belt
2. Hydrostatic
Transmission Pulley
3. Electric Clutch
Connector
Figure 22
1. Remove PTO belt (see Replacing PTO Belt).
2. Disconnect electric clutch connector.
3. Remove clutch stop.
CAUTION: Use care when releasing idler
spring tension. Keep body parts well away
from idler when performing this operation.
4. Disconnect idler spring.
5. Remove hydrostatic belt from hydrostatic
transmission pulleys, pulley, electric clutch, and
idler.
Install (Figure 22)
1. Install hydrostatic belt on idler, electric clutch,
pulley, and hydrostatic transmission pulleys.
2. Connect idler spring.
3. Install clutch stop.
4. Connect electric clutch connector.
5. Install PTO belt (see Replacing PTO Belt).
2
3
4
8
5
4. Pulley
5. Clutch Stop
6. Electric Clutch
7. Idler
8. Idler Spring
OE0320
7 - 23