Power-Up Self-Check Errors; Table 4-3. Power-Up Self-Check Error Codes - Motorola ASTRO XTS 5000 Detailed Service Manual

Troubleshooting Procedures: Power-Up Self-Check Errors
4.5

Power-Up Self-Check Errors

Each time the radio is turned on, the MCU and DSP perform a series of internal diagnostics. These
diagnostics consist of checking such programmable devices as the FLASH ROMs, the EEPROM,
and SRAM devices.
Problems detected during the power-up self-check routines are presented as error codes on the
radio's display. For non-display radios, the problem is presented at power up by a single, low-
frequency tone.
recommended corrective action.
Error
Code
01/02 FLASH ROM codeplug Checksum Non-Fatal Error
01/12 Security Partition Checksum Non-Fatal Error
01/20 ABACUS Tune Failure Non-Fatal Error
01/22 Tuning Codeplug Checksum Non-Fatal Error
01/81 Host ROM Checksum Fatal Error
01/82 FLASH ROM Codeplug Checksum Fatal Error
01/88 External RAM Fatal Error — Note: Not a checksum error
01/90 General Hardware Failure Fatal Error
01/92 Security Partition Checksum Fatal Error
01/93 FLASHport Authentication Code Failure
01/98 Internal RAM Fail Fatal Error
01/A2 Tuning Codeplug Checksum Fatal Error
02/81 DSP ROM Checksum Fatal Error
02/88 DSP RAM Fatal Error — Note: Not a checksum error
02/90 General DSP Hardware Failure (DSP startup message not
received correctly)
09/10 Secure Hardware Failure
09/90 Secure Hardware Fatal Error
6881094C31-C
Table 4-3 lists possible error codes, a description of each error code, and a

Table 4-3. Power-Up Self-Check Error Codes

Description Corrective Action
Reprogram the codeplug
Send radio to depot
Turn radio off, then on
Send radio to depot
Send radio to depot
Reprogram the codeplug
Send radio to depot
Turn radio off, then on
Send radio to depot
Send radio to depot
Send radio to depot
Send radio to depot
Send radio to depot
Turn radio off, then on
Turn radio off, then on
Turn radio off, then on
Turn radio off, then on
October 14, 2003
4-5