Table of Contents
Advertisement
Connecting the DisplayPort (DP to DP) cable
NOTE: The default out of factory setting in the U3818DW is DP1.2. If the monitor
fails to show any content after the DP cable is connected, follow the procedures
below to change the settings from DP1.2 to DP1.1:
•
Press second button next to the
•
Use the
enter the submenu.
•
Use the
•
Press and hold the
configuration message appears.
•
Use the
Repeat the above steps to change the DP format settings if necessary.
Connecting the USB Type-C cable
28
|
Setting Up the Monitor
and
buttons to highlight Input Source, then use the
and
buttons to highlight DP.
button for approximately 10 seconds, and the DP
button to select Disable and change the settings.
button to activate the OSD menu.
button
Hide quick links:
Advertisement
Table of Contents
