Related Manuals for Nitec Hex-Par 12
Summary of Contents for Nitec Hex-Par 12
- Page 1 LED PAR with 6-in-1 RGBAW+UV LEDs projects perfectly mixed and finely tunable colors...
-
Page 2: Table Of Contents
11-channel mode 6-channel mode STAND-ALONE OPERATION INFRARED (IR6) REMOTE CONTROL OPERATION MASTER/SLAVE OPERATION (via DMX cable) MASTER/SLAVE OPERATION (via UFI wi-fi) OPERATING MODE PRIORITY RANK MAINTENANCE PACKING CONTENT - HEX-PAR 12 - Power cord - User Manual - Warranty Card... - Page 3 WARNING! Before carrying out any operations with the unit, carefully read this instruction manual and keep it with cure for future reference. It contains important information about the installation, usage and maintenance of the unit. SAFETY General instruction • The products referred to in this manual conform to the European Community Directives and are there- fore marked with .
-
Page 4: Introduction
MASTER/SLAVE OPERATION (via UFI wi-fi transceiver) HEXPAR 12 is an LED PAR with 6-in-1 RGBAW+UV LEDs that HEX-PAR 12 units can operate in Master/Slave mode wirelessly using the optional UFI wi-fi projects perfectly mixed and finely tunable color. transceiver. The master UFI-enabled unit can be operated in stand-alone mode, with the UFI set to transmit. -
Page 5: Overview
OVERVIEW MASTER/SLAVE OPERATION (via DMX cable) When multiple HEX-PAR 12 units are used together, Master/Slave mode enables the Rear View assignment of one master unit and multiple slave units. The master unit can be operated in stand-alone mode (i.e., auto program or sound-active mode -- not DMX mode). The slave units should all be set to slave mode as described below. -
Page 6: Dimensions
DIMENSIONS INFRARED (IR6) REMOTE CONTROL OPERATION The IR6 infrared controller enables remote control of the HEX-PAR 12. To pair the IR6 to the HEX-PAR 12, follow these steps: 1. Press MENU button until SEr is displayed 2. Press ENTER 3. Press UP or DOWN to turn infrared operation ON or OFF 4. -
Page 7: Control Menu Overview
STAND-ALONE OPERATION CONTROL MENU OVERVIEW PRESET COLOR MODE Press MENU button until C-- is displayed CONTROL PANEL Press ENTER Press UP or DOWN to select C1 - C63 Press ENTER BUTTON FUNCTION AUTO PROGRAM MODE Menu Selects operating mode or exits submenus Press MENU button until P-- is displayed Press ENTER Scrolls up through option lists or selects higher value... -
Page 8: Ufi Operation
000 --- 255 0–100% 2) Set the UFI sending/receiving channel Blue 000 --- 255 0–100% 3) Attach the UFI to the HEX-PAR 12 USB port 4) Use Dipswitch 5 to select UFI send or receive mode. Amber 000 --- 255 0–100% White 000 --- 255 0–100%...