Summary of Contents for Nitec photon 80
- Page 1 Compact RGB LED PAR utilizing the latest in Chip On Board technology to project saturated perfectly mixed colors...
-
Page 2: Table Of Contents
OPERATING MODE PRIORITY RANK STAND-ALONE OPERATION INFRARED (IR6) REMOTE CONTROL OPERATION MASTER/SLAVE OPERATION (via DMX cable) MASTER/SLAVE OPERATION (via UFI wi- ) MAINTENANCE PACKING CONTENT - PHOTON 80 - Fresnel lens - Power cord - User manual - Warranty Card... - Page 3 WARNING! Before carrying out any operations with the unit, carefully read this instruction manual and keep it with cure for future reference. It contains important information about the installation, usage and maintenance of the unit. SAFETY General instruction • The products referred to in this manual conform to the European Community Directives and are there- fore marked with .
-
Page 4: Introduction
INTRODUCTION MASTER/SLAVE OPERATION (via UFI wi- transceiver) PHOTON 80 is a ompact RGB LED PAR utilizing the latest in Chip On Board technolo- PHOTON 80 units can operate in Master/Slave mode wirelessly using the optional UFI wi- gy to project saturated perfectly mixed colors. -
Page 5: Overview
OVERVIEW MASTER/SLAVE OPERATION (via DMX cable) When multiple PHOTON 80 units are used together, Master/Slave mode enables the assignment of one master unit and multiple slave units. The master unit can be operated in stand-alone mode or by IR6 infrared remote control. The slave units should all be set to Mounting bracket slave mode. -
Page 6: Dimensions
DIMENSIONS INFRARED (IR6) REMOTE CONTROL OPERATION The (optional) IR6 infrared controller enables remote control of the PHOTON 80. To pair the IR6 to the PHOTON 80, follow these steps: 1. Press MENU button until Ser is displayed 2. Press ENTER 3. -
Page 7: Control Menu Overview
OPERATING MODE PRIORITY RANK CONTROL MENU OVERVIEW Higher priority control modes override lower priority modes CONTROL PANEL 1. UFI 2. DMX (wired) 3. Infrared (IR6 remote) BUTTON FUNCTION 4. Manual (onboard menu) Menu Selects operating mode or exits submenus STAND-ALONE OPERATION Scrolls up through option lists or selects higher value Down AUTO PROGRAM MODE... - Page 8 To enable wireless DMX operation via the optional UFI wi- transceiver: 8-CHANNEL MODE 1) Set the PHOTON 80 starting DMX address 2) Set the UFI sending/receiving channel 3) Attach the UFI to the PHOTON 80 USB port Channel Function Value Percent/Setting 4) Use Dipswitch 5 to select UFI send or receive mode.