Service ............ 17 Checklist before use ......7 Checklist for periodic inspection ....18 CE Declaration ........19 Molift Mover 300 - use ......7 Lift and transfer ........8 Use of spread legs ........8 Using lifting slings ........8 Safety devices ........9 Emergency stop and lowering ....
About Molift Mover 300 Explanation of symbols Molift Mover 300 is a mobile lifter intended for lift- This symbol is used to point out instructions ing and transferring persons to/from bed, floor, and information related to workplace safety chair or similar, wheelchair and toilet. The lift-...
A Molift Mover 300 shall only be used when all Torn, cut, frayed or broken slings can fail, re- safety devices and equipment is in place and fully sulting in serious injury to the user.
If dam- aged, check the content and contact your deal- er for assistance if components are damaged. • The box contains one complete Molift Mover 300 lifter with hand control, battery and bat- tery charger with mains cable.
(+5 to +40°C). Following storage or transport at other temperatures leave the lifter in a room with a suitable temperature until it reaches a safe operating temperature. Page 6 of 20 BM06101 Molift MOVER 300 English Rev E 24/09/2013...
Molift representative. Battery Molift Mover 300 - use lamp The Molift Mover 300 hand control has four but- tons, two buttons for up and down, and two but- Legs in Legs out tons for adjusting the adjustable legs in and out.
Lift and transfer Using lifting slings The Molift lifting slings are easy to use. Please see The suspension shall always be positioned across the user manual that comes with the sling for spe- the user as shown left in the illustration below.
Safety devices Electrical emergency lowering It is possible to perform an emergency lowering of Molift Mover 300 is equipped with several safety the lifting arm in case of a general malfunction of devices, which are intended to prevent damage to the control electronics.
Battery care and charging If the battery is discharged during a lift, it Molift Mover 300 is supplied with a battery with a is always enough power to lower the user 26,4 V cell unit that is placed in the battery hold- down again.
Maximum internal width 1065 mm to 700 mm Internal width at maximum reach 950 mm Base height 115 mm Minimum internal width 58,5 mm Base clearance 43 mm Rev E 24/09/2013 BM06101 Molift MOVER 300 English Page 11 of 20...
Part no 3023400 Part no 3024400 Part no 3023500 Part no 3024500 Molift Basic Full Sling Size With head support Part no 3047010 Part no 3074011 Part no 3047012 Page 12 of 20 BM06101 Molift MOVER 300 English Rev E 24/09/2013...
Page 13
Part no 3050200 Part no 3050300 Part no 3050400 Read the user manual that comes with the sling for specific instructions Bag for slings - Part no 3048000 Rev E 24/09/2013 BM06101 Molift MOVER 300 English Page 13 of 20...
• 2 points steel, Small, size 350 Scale before use. Part no: 1430008 The suspensions can be used on other Molift lift- Change to suspension with scale with quick re- ers with the same quick release. If the suspension lease as you change to any other suspension.
If you do not know whom to contact locally, please contact your dealer or Etac Supply Gjøvik to get help. Rev E 24/09/2013 BM06101 Molift MOVER 300 English Page 15 of 20...
• Regular cleaning is recommended and should be implemented in the suitable cleaning rou- tines. Page 16 of 20 BM06101 Molift MOVER 300 English Rev E 24/09/2013...
Service Molift Mover 300 has a LED on the battery holder indicating if the lifter needs service. The LED gives a green light when the lifter is ready for use. Battery lamp Service lamp Electrical emer- gency lowering The electronics logs how much the lifter is being used, and the load it is used with.
Completed Compulsory where lifter has been checked and approved: The lifter has passed the safety check and been affixed with the Molift safety check label, duly dated and signed. The ticked and signed checklist has been passed to the client and a copy sent to your Molift dealer.
Need help?
Do you have a question about the Mover 300 and is the answer not in the manual?
Questions and answers