Advertisement
The unit will start searching automatically and stop when a radio station is
found. Release the knob once a station has been found.
5. Repeat the above step until your desired radio station is found.
6. Adjust the volume knob to your desired volume level.
7. AM reception: the receiver has a built-in AM bar antenna. If reception is weak,
slightly rotate or reposition the unit to improve AM reception.
8. FM reception: the receiver has a built-in FM wire antenna hanging at the rear
cabinet. For best reception, completely unravel and extend this wire.
9. When you have finished listening to the radio, turn the volume knob in a
counterclockwise direction to switch the unit off. Unplug it from the power supply
if you are not going to use it for a while.
FM and FM-stereo mode
• FM mode: use the radio band selector to select the FM band. Programs are
received in mono mode. Use this mode when stereo reception is weak.
• FM-Stereo mode: use the radio band selector to select FM-ST for receiving
stereo programs. Once a stereo signal is received, the ST icon will light up on the
display.
The record player
IMPORTANT!
When using the turntable:
• Make sure to remove the stylus protector, as illustrated on the right. (It should
easily slide off the stylus assembly.)
Advertisement
