3.2 Restoring from Power Save Mode
Under the condition that Power save mode is enable: The power save mode "SLEEP"
LED is lit.
If you try to start scanning during the power save mode, the power save mode "SLEEP"
LED turns off and warming up will begin.
【During warming up】
【Finish warming up】
The power LED is lit, the Status LED starts
blinking rapidly, and the device will be in
warming up condition. . (It takes about 20
seconds to warm up depending on
temperature.)
After warming up, the Status LED starts
blinking slowly and the device will be ready for
scanning.
3. Power Save Mode
3-3
3