Technical Specifications - Slendertone Bottom Instruction Manual

technical specifications

Caring for your unit
Your unit should not be allowed to get wet or be left in excessive sunlight. It may be
cleaned regularly using a soft cloth, lightly dampened in soapy water. Do not allow the
interior of your unit to become wet. Do not use detergents, alcohol, spray aerosols or
strong solvents on your unit.
Access to the interior of the unit is not required for maintenance purposes.
If your unit is damaged, you should not use it but should return it to
local distributor for replacement or repair. Repairs, service and modifications may not
be carried out by anyone other than qualified service personnel authorised by
.
TONE
: Under no circumstance should anything other than the correct type of batteries
IMPORTANT
– (rechargeable batteries 3.6V NiMH) be used with your unit. These can be purchased
from the careline.
SLENDERTONE
Disposing of the pads and batteries
Used pads and batteries must never be disposed of in a fire but in accordance with your
country's national laws governing the disposal of such items.
:
NOTES
• The signal gradually increases to a peak intensity level at the start of the contraction phase
(i.e. ramp up) and gradually decreases to nothing at the start of the relaxation phase
(i.e. ramp down). When the (i.e. ramp down). When the symbol is flashing, the stimulus is significantly reduced. symbol is flashing, the stimulus is significantly reduced.
• In accordance with the laws within the member state, safety testing on the device
should be carried out every two years.
• In compliance with German law, product safety testing must be conducted every two years
by an authorised test service.
Accessories:
You can purchase all accessories at www.slendertone.com. Under no circumstances
should anything other than
SLENDERTONE
or unit (Type 390). Any others may not be compatible with your unit and could
SLENDERTONE
degrade the minimum safety levels.
Garment (E:30)
SLENDERTONE BOTTOM
Pads: • 4 large pads (Type 716)
SLENDERTONE BOTTOM
Belt Extension
SLENDERTONE
Battery pack (3.6V, NiMH)
Battery Charger (EU - 2504-0303)
Battery Charger (US/Japan - 2504-0302)
Charger complies to EN 60950, Input: nominal voltage 100-240V, frequency 50-60Hz, current
125mA. Do not use any other chargers or any other power supplies.
Product Type: 396
Intended use: Muscle stimulator
Classification: Internally powered equipment, Class II charger, Type BF applied parts.
Waveform: Symmetrical bi-phasic square waveform when measured into a resistive load.
Environmental Specifications:
Operating: Temperature Range: 0 - 35°C (32 - 95°F)
Humidity: 20 - 65 % RH
Transport & Storage: Temperature Range: 0 - 35°C (32 - 95°F)
Humidity: 20 - 85 % RH
14
SLENDERTONE
accessories be used with your
SLENDERTONE
Description of your unit's symbols:
There are a number of technical markings on your unit. These can be explained as follows:
The unit and garment are manufactured for Bio-Medical Research Ltd, Parkmore
Business Park West, Galway, Ireland.
The unit requires 1 x 3.6 volt (NiMH) DC battery pack. DC is indicated by the symbol:
The Output Frequency indicates the number of pulses per second transmitted by the unit.
This is measured in hertz, which is indicated by "Hz".
Output (RMSA) means the maximum output root mean square current for each channel.
or your
Output (RMSV) means the maximum output root mean square voltage for each channel.
-
SLENDER
! This symbol means "Attention, consult the accompanying documents".
This symbol means type BF applied parts (electrodes).
This symbol on your unit is to indicate conformity to the requirements of the
Medical Device Directive (93/ 42/EEC). 0366 is the number of the notified body
0366
(VDE).
Conforms to UL STD 60601-1.
Certified to CAN/CSA.
STD C22.2 NO 601.1
SN stands for 'serial number'. On the back of the unit is the serial number specific to
this unit. The letter preceding the number indicates the year of manufacture, where "R"
denotes 2012, "S" denotes 2013 etc.
The garment's batch number is represented on the garment packaging, by the number
corresponding with the LOT symbol.
Rated Outputs – Voltage/Currents: E:30
Parameter
Output RMSV
charger
Output RMSA
Output Frequency
DC Component: Approx.
Positive Pulse Width:
Negative Pulse Width:
Interphase Interval:
Attention:
This unit can deliver currents in excess of 2mA/cm
At the end of the product lifecycle, do not throw this product into the normal
household garbage, but bring it to a collection point for the recycling of electronic
equipment.
Some product materials can be re-used if you bring them to a recycling point. By re-
using some parts or raw materials from used products you make an important contri-
bution to the protection of the environment. Please contact your local authorities if
you need more information about collection points in your area.
Waste Electrical and Electronic Equipment can have potentially harmful effects on the
environment. Incorrect disposal can cause harmful toxins to build up in the air, water
and soil and can be harmful to human health.
500Ω 1KΩ 1K5Ω
6.3V 11.2V 13V
12.6mA 11.2mA 8.6mA
50Hz 50Hz 50Hz
0 C 0 C 0 C
250-350µs 250-350µs 250-350µs
250-350µs 250-350µs 250-350µs
100 µs 100 µs 100 µs
if used with incorrect electrodes.
2
15