Mobile Air Conditioner Use and Care Manual Part Number: 048-GM-48265 Thank you very much for selecting this new model of Portable Air Conditioner, please read this Use and Care Manual carefully before installing and using this appliance. Please keep this Use and Care Manual properly for future reference.
※ Safety Cautions………………………………………………………………………………………3-4 ※ Features & Identification of Parts…………………………………………………………………….5 ※ Operations and Settings…………………………………………………………………………...6-11 ※ Installation and Adjustment……………………………………………………………………….11-13 ※ Drainage Instructions……………………………………………………………………………..13-14 ※ Multiple Protection Functions …………………………………………………………………….…14 ※ Maintenance……………………………………………………………………………………….15-16 ※ Trouble Shooting…………………………………………………………………………………..….17 ※ Appendix……………………………………………………………………………………………18-19 SAFETY CAUTIONS...
Page 3
Electrical Specifications All wiring must comply with local and national electrical codes and be installed by a qualified electrician. If you have any questions regarding to the following instructions, contact a qualified electrician. The unit must be installed in accordance with national wiring regulations. Check available power supply and resolve any wiring problems before installation and operation of this unit.
Keep the unit at least 1 meter away from TV or radios to avoid electromagnetic interference. Do not expose the unit under direct sun light to avoid surface color fading. Do not tilt the unit for more than 35 degrees or upside-down while transporting. Place the unit on a flat surface and upright with less than 5 degrees inclination.
Slant Panel of Adapter 1. Front panel 13. Drain cover 2. Remote control receiving window 14. Universal wheel 3. Control panel 15. Filter assembly of side panel 4. Top panel 16. Protective grid 5. Horizontal louver 17. Fastener 6. Right decoration board 18.
Page 6
This section explains proper mobile air conditioner operation. Display Window Mode Fan Speed Timer Down Power Control Panel Operation This unit is with Cooling, Heating, Dehumidifying, Fan and Energy Conversation & Sleep modes operations. 1. Energize the Unit Plug in and all icons in LCD display window will light up for 2 seconds and reminding music will be on, then LCD display ℉),...
Page 7
DEHUMIDIFY ----- ----- Temperature HEAT 16℃--30℃(60℉--86℉) Setting Range ----- ----- Energy Temperature 16℃--30℃(60℉--86℉) Conversation Setting Range : A. Touch to increase or decrease the temperature 1℃or 1℉ by pressing once. B. Touch over 2 seconds to continuously increase or decrease the temperature number by 0.5 second interval, temperature setting range is 16~30℃/60~86℉。...
:Touch this key to set unit auto turn-on /turn-off time, to check or cancel time setting. A. This unit is designed with 24-hour timer, first two digits are for hours 00-24, and last two digits are for minutes 00-60. You can increase or decrease half an hour each time by touching to finish hour and minute setting.
Page 9
The Remote controller transmits the signal to system. LCD display window Up and down button Power button Fan speed button Mode button Timer button Sleep Button Auto-swing button Auto clean button 1. Power: Press this button to start the unit when it is energized or stop the unit when it is in operation 2.
Page 10
Be sure to note proper polarity of batteries Notes: Use alkaline batteries only. Do not use rechargeable batteries. When replace batteries, always replace both batteries with new batteries, do not mix old and new batteries. If the air conditioner will not be used for an extended period of time, remove the batteries from the remote control.
Remote Control Hold direction Remote Control Open and Close Direction Remote Control Box Installation & Adjustment 1. Installation Warning: Keep this mobile air-conditioner in upright position at least 2 hours before first installation. This air-conditioner may be moved indoor conveniently; keep the unit in upright position while moving it. The air-conditioner shall be placed at flat surface.
Page 12
Fastener Slot Exhaust Hose - Assembly Figure 2 Put front end of exhaust hose assembly onto jugged position of exhaust air outlet at back panel, fasteners will lock the exhaust hose assembly. (As Figure 2) Note: Keep the right direction of slant side of adapter, for ease installation of window seal-plate. Keep exhaust hose connected in good position.
Figure 5 Install the rectangle end of exhaust hose assembly into the corresponding rectangle hole in window seal-plate assembly, fix it with screw and close the window (as Figure 6) Slant panel of adapter Window Window Note: Slide the adapter downwards and assure adapter installed in good position. Assure the slant panel direction to match seal-plate direction.
5. Water stopper and drain cover must be tightly installed, to avoid new condensate to wet the floor or carpet when the unit re-starts working. 2. Continuous drainage: 1). Screw off the drain-cover & unplug the water stopper. 2). Connect drain-hole with φ12mm drain hose, as deep as possible to avoid leakage. 3).
4. Delay protection function of compressor This unit offers restart protection to compressor. Except that the compressor may start immediately when the unit is energized first time, there is 3-minute delay re-start protection after compressor is shut down. Maintenance and Service Note: Be sure to turn off the unit and pull out the plug before maintain or send to service center.
Page 16
Side filter frame Lower filter frame 2.2 Installation of the filter Pull direction Lower filter Side filter Aim the end of the filter toward slot then push filter gently into slot. Note: 1. Be sure to install the filter to side panel then for the filter to back panel 2.
Troubleshooting Please check the unit and suggestions below before asking for professional service, but never dismantle or repair the unit by yourself, it may cause harm to you and your property. Trouble Cause Remedy Connect the unit to a live socket and turn it Power supply failure Water-full and its icon lighting Drain the water stored in the unit.
Page 18
Voltage: 250V Current: 3.15A Schematic diagram of the air-conditioner Capillary Evaporator Condenser Cooling Compressor Heating For specific technical parameters of the model, refer to rating label on the product. Correct Disposal of this product This marking indicates that the product should not be disposed with other household wastes throughout the EU.
Need help?
Do you have a question about the 048-GM-48265 and is the answer not in the manual?
Questions and answers