Advertisement
Bulletin No: 09-036/14
© 2014 Mazda Motor of America, Inc.
30. Replace the front sash molding. Refer to MS3 online or Workshop Manual (section 09-16 REAR SASH
MOLDING REMOVAL) and (section 09-16 REAR SASH MOLDING INSTALLATION).
31. Prepare 1 set of 2 pieces cut Form Rubber C 20mm X 40mm size in layer as shown.
Piece
Sheet Type
C
Form Rubber
32. Attach the Form Rubber C to the back side of rear door module panel, positioning one end at the edge of the
rear door trim as shown.
33. Install a new rear door trim and rear beltline molding. Refer to MS3 online or Workshop Manual (section 09-
17 REAR DOOR TRIM REMOVAL/INSTALLATION) and (section 09-17 REAR BELTLINE MOLDING
REMOVAL/INSTALLATION).
34. Verify repair.
Last Issued: 08/29/2014
Sheet Thickness
5mm
Size
20mm X 40mm
Quantity
2
Page 14 of 16
Advertisement
