Advertisement
Bulletin No: 09-036/14
© 2014 Mazda Motor of America, Inc.
REAR DOOR
22. Fully open the rear door glass.
23. Remove the rear door trim. Refer to MS3 online or Workshop Manual (section 09-17 REAR DOOR TRIM
REMOVAL/INSTALLATION).
24. Remove the inner weather strip.
25. Install a new inner weather strip, and then slide it until it contacts the rear glass run channel.
26. Remove the rear beltline molding. Refer to MS3 online or Workshop Manual (section 09-17 REAR BELT-
LINE MOLDING REMOVAL/INSTALLATION).
27. Pull both edges of the rear glass run channel (A) and remove it from the rear door the same procedure as
the front glass run channel.
28. Apply soap sud to the contacting surface of the new rear glass run channel to the rear door glass and door
panel.
29. Insert both ends of the rear door glass run channel (A) between the rear door glass and door panel, then
install the whole rear door glass run channel using the same procedure as the front glass run channel.
Last Issued: 08/29/2014
Page 13 of 16
Advertisement
