Power Supply; Using The External Dc Power Supply - Panasonic AU-V35LT1G Operating Instructions Manual

Power supply

Using the external DC power supply

<DC IN> terminal
1
Connect the external DC power supply to the <DC IN> terminal of the camera.
2
Turn on the power switch of the external DC power supply (if the external DC power
supply has a power switch).
3
Turn the power switch of the camera to <l>.
r External DC power supply
Connect after making sure that the output voltage of the external DC power supply is compatible with the rated
voltage of the camera.
Select an output amperage for the external DC power supply with a margin above the total amperage of the
connected devices.
The total amperage of connected devices can be calculated with the following formula.
Total power consumption ÷ Voltage
When the power of the camera is turned on, inrush current is generated. Insufficient power supply when turning
on the power may cause a malfunction. We recommend that you use an external DC power supply that can
assure double the capacity of the total power consumption of the camera and connected devices that are turned
on by interlock when the power of the camera is turned on (such as lenses). For the DC cable, use a dual-core
shielded wire of AWG16 (nominal cross section area 1.309 mm
f Make sure of the pin alignment of the DC output terminal of the external DC power supply and the camera
<DC IN> terminal, and connect the polarity correctly.
If the +12 V power supply is mistakenly connected to the GND terminal, it may cause fire or malfunction.
External DC power supply
DC cable
) or thicker.
2
Power supply
27