Section 1: Safety Rules & General Information Introduction; Read This Manual Thoroughly; How To Obtain Service - Generac Power Systems 15 kW EcoGen Installation Manuallines

Section 1: Safety Rules & General Information
Introduction
Thank you for purchasing
performance, variable speed, air-cooled, engine-driven
stationary automatic standby generator set. Every effort
has been made to ensure that the information and
instructions in this manual are both accurate and
complete at the time of release. However, the
manufacturer reserves the right to change, alter, or
otherwise improve this product at any time without prior
notice.
In off–grid applications as a part of an alternative energy
system, the generator starts when the inverter/battery
charger detects the normal power source voltage has
dropped below a preset level. The generator powers the
inverter and, once the voltage level of the battery rises to
an acceptable level, the generator is shut down. Another
off–grid application would be for use in remote locations
such as for pumping water for a village or campground,
or for livestock.
The unit is factory installed in an all–weather metal
enclosure and is intended for outdoor installation
only. The generator can be operated using either natural
gas (NG) or vapor withdrawn liquid propane (LP).
NOTE: When properly sized, this generator is suitable
for supplying typical residential loads such as induction
motors (sump pumps, refrigerators, air conditioners,
furnaces, etc.), electronic
monitor, TV, etc.), lighting loads and microwaves, or
loads less than 10 kW or 2 hp.
The information in this manual is accurate based on
products produced at the time of publication. The
manufacturer reserves the right to make technical
updates, corrections, and product revisions at any time
without notice.

Read This Manual Thoroughly

WARNING
Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.
If any portion of this manual is not understood, contact
the nearest Independent Authorized Service Dealer
(IASD) for starting, operating, and servicing procedures.
This manual must be used in conjunction with the
appropriate owner's manual.
Installation Guidelines For 60 Hz EcoGen™ Generators
this compact, high-
components (computer,
(000100a)
Safety Rules & General Information
SAVE THESE INSTRUCTIONS: The manufacturer
suggests that this manual and the rules for safe operation
be copied and posted near the unit installation site.
Safety should be stressed to all operators and potential
operators of this equipment.
Throughout this publication and on tags and decals
affixed to the generator, DANGER, WARNING, and
CAUTION blocks are used to alert personnel to special
instructions about a particular operation that may be
hazardous if performed incorrectly or carelessly. Observe
them carefully. Their definitions are as follows:
DANGER
Indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
WARNING
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
CAUTION
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
NOTE: Notes provide additional information important to
a procedure or component.
Safety alerts cannot eliminate the hazards they indicate.
Observing safety precautions and strict compliance with
the special instructions while performing the action or
service are essential to preventing accidents.
The operator is responsible for proper and safe use of
the equipment. The manufacturer strongly recommends
that if the operator is also the owner, to read the owner's
manual and thoroughly understand all instructions before
using this equipment. The manufacturer also strongly
recommends instructing other users to properly start and
operate the unit. This prepares them if they need to
operate the equipment in an emergency.

How to Obtain Service

When the generator requires servicing or repairs, contact
an IASD for assistance. Service technicians are factory-
trained and are capable of handling all service needs.
Please visit the dealer locater at:
Service/DealerLocator/
(000001)
(000002)
(000003)
www.generac.com/
to locate the nearest IASD.
1