EN 56
12.
12.14.3. CPU Fan Subassembly Removal
1.
Remove the CPU heat sink. See paragraph 12.14.1.
2.
Remove the cable tie (7) from the CPU fan cable. See Figure 12.14-1.
3.
Remove the 2 mounting screws (8) from the CPU fan subassembly. See Figure 12.14-4.
4.
Remove the CPU fan cable from the cable clip (9). See Figure 12.14-5.
5.
Remove the CPU fan subassembly from the chassis.
8
12.14.4. CPU Fan Subassembly Re-Assembly
To re-assemble the CPU fan subassembly, do all steps described in paragraph 12.14.3 in reverse order.
Note:
The torque setting required for the CPU fan subassembly mounting screws (8) is 8 kg-cm.
Note:
Cables must be re-assembled into the cable clip in the following order: right WLAN antenna cable, CPU fan cable, IR blaster
cable, and VFD USB cable.
Note:
Fit replacement cable ties after re-assembly.
12.14.5. CPU Fan Removal
1.
Remove the CPU fan subassembly. See paragraph 12.14.1.
2.
Remove the 4 mounting screws (10) from the CPU fan. See Figure 12.14-6.
3.
Remove the fan from the CPU fan cage.
10
10
12.14.6. CPU Fan Re-Assembly
To re-assemble the CPU fan, do all steps described in paragraph 12.14.5 in reverse order.
Note:
The torque setting required for the CPU fan mounting screws (10) is 8 kg-cm.
MCP9360i
Hardware Repair
Figure 12.14-4
10
10
Figure 12.14-6
8
9
Figure 12.14-5