Philips MCP9360i Service Manual page 47

12.8.4. Right Wireless Antenna Re-Assembly
To re-assemble the right wireless antenna, do all steps described in paragraph 12.8.3 in reverse order.
Note: The torque setting required for the antenna mounting screws (6) is 2 kg-cm.
The torque setting required for the VFD mounting screws (4) is 6 kg-cm.
The torque setting required for the CPU fan mounting screws (3) is 8 kg-cm.
12.8.5. Left Wireless Antenna Removal
1. Remove the top cover. See paragraph 12.1.1.
2. Remove the main bezel. See paragraph 12.2.1.
3. Remove the HDD subassembly. See paragraph 12.3.1.
4. Remove the ODD. See paragraph 12.4.1.
5. Remove the riser card subassembly. See paragraph 12.5.1.
6. Remove the 2 mounting screws (7) from the antenna. See Figure 12.8-5.
7. Disconnect the left antenna cable from the WLAN card.
8. Remove the antenna from the chassis.
12.8.6. Left Wireless Antenna Re-Assembly
To re-assemble the left wireless antenna, do all steps described in paragraph 12.8.5 in reverse order.
Note: The torque setting required for the antenna mounting screws (7) is 2 kg-cm.
6
6
Figure 12.8-4
7 7
Figure 12.8-5
Hardware Repair MCP9360i 12. EN 47