LG U310 Service Manual page 30

3. TECHNICAL BRIEF
3.5.6 Dual band GSM power amplifier (U1001)
The SKY77318 Power Amplifier Module (PAM) is designed in a low profile (1.2 mm), compact form
factor for tri-band cellular handsets comprising GSM900, DCS1800, and PCS1900 operation. The
PAM also supports Class 12 General Packet Radio Service (GPRS) multi-slot operation.
The module consists of separate GSM900 PA and DCS1800/PCS1900 PA blocks, impedance-
matching circuitry for 50 Ω input and output impedances, and a Power Amplifier Control (PAC) block
with an internal current-sense resistor. The custom BiCMOS integrated circuit provides the internal
PAC function and interface circuitry.
Fabricated onto a single Gallium Arsenide (GaAs) die, one Heterojunction Bipolar Transistor (HBT) PA
block supports the GSM900 bands and the other supports the DCS1800 and PCS1900 bands. Both
PA blocks share common power supply pins to distribute current. The GaAs die, the Silicon (Si) die,
and the passive components are mounted on a multi-layer laminate substrate. The assembly is
encapsulated with plastic overmold.
RF input and output ports of the SKY77318 are internally matched to a 50 Ω load to reduce the
number of external components for a quad-band design. Extremely low leakage current (2.5 µA,
typical) of the dual PA module maximizes handset standby time. The SKY77318 also contains band-
select switching circuitry to select GSM (logic 0) or DCS/PCS (logic 1) as determined from the Band
Select (BS) signal. In Figure 3.5.6-1 below, the BS pin selects the PA output (DCS/PCS OUT or
GSM900 OUT) and the Analog Power Control (VAPC) controls the level of output power.
The VBATT pin connects to an internal current-sense resistor and interfaces to an integrated power
amplifier control (iPAC™) function, which is insensitive to variations in temperature, power supply,
process, and input power. The ENABLE input allows initial turn-on of PAM circuitry to minimize battery
drain.
Figure 3.5.6-1 GSM PA functional block diagram
- 31 -