Dea REV Series Operating Instructions Manual page 10

4
Selection of direction of motion
1. Scroll down the parameters with
until you visualise P063;
2. Access the parameter by pressing the
3. Acting on and keys, set:
- d000=motor in standard position (on the left of
the gap);
- d001=motor in inverted position (on the right of
the gap);
4. Confirm your choice by pressing the
splay returns again to P063).
Warning: The parameter automatically reverses
the motors output open/close and any limit switch
input open/close.
5
How to adjust the limit switche
1. Scroll down the parameters untill you visualize
P001;
2. confirm by pressing the
3. by pressing (open) and
leaf in the opening position and adjust the limit
switch cam so that it pushes the microswitch in
that point;
Repeat adjusting the closing limit switch.
4. Confirm by pressing the
again P001).
6
Motor stroke learning
1. Make sure you have properly adjusted the opening/closing limit switches cams;
2. Scroll down the parameters with
3. Access the parameter by pressing the
4. When " " flashes, continue pressing the
5. Release the key when "
6. Wait for the door searches and stops on the opening stop and then on the closing stop.
7. Once the procedure is ended, the display will show "----".
7
Transmitters learning
7.1 Transmitters coding selection
1. Scroll down the parameters with
P027;
2. Confirm by pressing on the
3. Select the type of transmitter by scrolling
- d000=fix rolling-code (suggested);
- d001=complete rolling-code;
- d002=dip-switch;
4. Confirm by pressing on the
Warning: If you need to vary the type of encoding, and only if other
remotes with different encoding are memorized, you need to erase
memory (P004) AFTER you have set the new encoding.
and keys
key;
key (di-
key;
(close), move the
key (display shows
and keys until you visualise P003;
key;
key;
" stops flashing; Start the learning procedure with operator 1 opening;
and keys until you visualise
key;
and keys:
key (display shows again P027).
27