Troubleshooting
Fault
1. Blade speed too high for feed
Bad cuts (rough)
2. Blade is too coarse.
1. Blade is binding in the cut.
Blade is twisting
2. Blade tension too high
1. Blade guides worn
2. Blade guide bearings not adjusted.
Unusual wear on
side/back of blade
3. Blade guide bearing bracket is
Parts
Replacement Parts
Replacement parts are listed on the following pages. To order parts or reach our service department, call
800-274-6848 between 7:30 a.m. and 5:30 p.m. (CST), Monday through Friday. Having the Model
Number and Serial Number of your machine available when you call will allow us to serve you quickly and
accurately.
Probable Cause
pressure.
loose.
1. Reduce
pressure.
2. Replace with finer blade.
1. Decrease feed pressure.
2. Decrease tension on Blade
1. Replace blade guides.
2. Adjust blade guide bearings.
3. Tighten blade guide bearing bracket.
18
Suggested remedy
blade
speed
and
feed