Operating Modes - SATO LC400e Series Operator's Manual

3.3 OPERATING MODES

This section provides an overview of the various configuration modes of the operation menu. All the
configuration activities are performed via the use of the operator panel located on the printer's face. However,
many settings may also be controlled via external software commands. In the case of conflict between
external software commands and internal software commands (control panel settings) the printer will always
use the last valid setting (the default is software commands).
There are several modes of operation. To enter the desired mode, the button sequence combination listed
below must be performed.
POWER: OFF
Power on
LINE + Power on
FEED + Power on
LINE + FEED +
Power on
DSW2-4 ON + LINE +
FEED + Power on
DSW2-6 ON +
Power on
DSW2-6 ON + LINE +
FEED + Power on
DSW2-7 ON +
LINE + Power on
DSW2-7 ON + LINE +
FEED + Power on
DSW2-4 ON +
Power on
LC400e Series Operator Manual
Normal mode
ONLINE
QTY: 000000
Advanced mode
ADVANCED MODE
Counter mode LINE
COUNTERS MODE
Test Print mode
TEST PRINT MODE
CONFIGURATION
Default setting mode
DEFAULT SETTING
YES NO
Maintenance mode
DSW2-4 OFF
MAINTENANCE MODE
DIPSW2-4 ON->OFF
Flash Memory Download mode
FLASH DOWNLOAD
READY
Boot Download mode
BOOT DOWNLOADER
PRESS FEED KEY
User Download mode
USER DOWNLOAD
PRESS LINE KEY
Protocol Initialization mode
ALT. PROTOCOL
DEFAULT COMPLETE
HEX Dump mode
ONLINE
QTY: 000000
Section 3: Operation and Configuration
LINE
OFFLINE
000000
Card mode
LINE
CARD MODE
Service mode
LINE
SERVICE MODE
FACTORY MODE
LINE
LINE
ALL CLEAR MODE
LINE
Page 3-7