How To Load Fan-Fold Media - SATO LC400e Series Operator's Manual

2.3 HOW TO LOAD THE MEDIA (cont'd)
8.
Remount the print head by turning the head lock lever clockwise until it latch on. The print head should
lock into place firmly.
9.
After loading the media and the carbon ribbon, close the top cover and do a test print to check that the
media roll has been loaded properly. See Section 3.9 Test Print Mode for instructions on how to run test
print.
Note
• Be careful not to get your fingers pinched while closing the top cover.
• To load the media in the dispenser, please refer to Section 2.3.3 To Route the Label when Using
the Optional Dispenser, for further instructions.
Caution
• The print head and its surroundings are hot after printing. Be careful not to touch it, to avoid being
burned.
• Touching the edge of the print head with your bare hand could cause injury.

2.3.2 How to Load Fan-fold Media

If using fan-fold media, set them on a flat surface behind the printer and remove the cover from the external
media slot on the rear panel. Pass the labels (printing side up) through the slot and over the media holder.
Refer to Figure 2-5.
Route the label following the steps explained for the media roll above.
LC400e Series Operator Manual
Figure 2-5, Fan-fold Media Loading
Section 2: Installation
External
media slot
Media guide
Page 2-5