To Route The Label When Using The Optional Dispenser; To Route The Label When Using The Optional Cutter - SATO LC400e Series Operator's Manual

Section 2: Installation
2.3 HOW TO LOAD THE MEDIA (cont'd)

2.3.3 To Route the Label when Using the Optional Dispenser

1.
Follow the procedures in Section 2.3.1 How to Load Media Roll, from step 1 to 7, to load the media roll
onto the media holder.
2.
Press the front cover lock lever to open the front cover.
3.
Peel off the first three leading labels from the liner (backing paper) and then pull out the leading liner
(backing paper) from the media holder.
Pass the liner (backing paper) over the dispenser plate and route liner (backing paper) as shown on the
Figure 2-6.
Dispenser plate
4.
Wrap the liner (backing paper) under and around the rewind spindle, routing it under the two retainer
prongs.
5.
Manually turn the rewind spindle counterclockwise to take up all the slack in the liner (backing paper).
6.
Close the front cover until the front cover lock lever engages and remount the print head.

2.3.4 To Route the Label when Using the Optional Cutter

Route the label following the steps explained for the media roll above in Section 2.3.1 How to Load Media
Roll.
Page 2-6
Label
Liner
LC400e series printer with optional dispenser installed
Figure 2-6, Label Dispenser Routing
LC400e series printer with optional cutter installed
Figure 2-7, Label Cutter routing
Media roll
Rewind spindle
Media roll
LC400e Series Operator Manual