Installing The Cisco Microsoft Windows Usb Device Driver - Cisco ASR 903 Installing Manual

Hide thumbs Also See for ASR 903:

Table of Contents

Connecting Console Cables

To disconnect the Linux USB console from the Terminal window

Enter Ctrl-a followed by : then quit

Installing the Cisco Microsoft Windows USB Device Driver

A USB device driver must be installed the first time a Microsoft Windows-based PC is connected to the USB

serial port on the router.

Installing the Cisco Microsoft Windows XP USB Driver

This procedure shows how to install the Microsoft Windows XP USB driver. Download the driver for your

router model from the Tools and Resources Download Software site, USB Console Software category, at the

following URL:

http://tools.cisco.com/support/downloads/go/Redirect.x?mdfid=268437899

Step 1

Unzip the file Cisco_usbconsole_driver_X_X.zip (where X is a revision number).

Step 2

If using 32-bit Windows XP double-click the file setup.exe from the Windows_32 folder, or if using 64-bit Windows

XP double-click the file setup(x64).exe from the Windows_64 folder.

Step 3

The Cisco Virtual Com InstallShield Wizard begins. Click Next.

Step 4

The Ready to Install the Program window appears, Click Install.

Step 5

The InstallShield Wizard Completed window appears. Click Finish.

Step 6

Connect the USB cable to the PC and router USB console ports. The EN LED for the USB console port turns green, and

within a few moments the Found New Hardware Wizard appears. Following the instructions to complete the installation

of the driver.

Step 7

The USB console is ready for use.

Cisco ASR 903 and ASR 903U Aggregation Services Router Hardware Installation Guide

Installing the Cisco ASR 903 Router

Table of Contents