Table of Contents
Advertisement
04 Interior
Front seats
Power seats (option)
04
Seat adjustment controls
The power driver's seat can be adjusted:
• If the ignition key is in position I or II.
• During a 10 minute period after the doors
have been unlocked if the door remains
open.
• If the door is closed and the ignition key is
not yet in the ignition, or if the key is in
position 0, the seat can be adjusted or
during a period of 40 seconds. The power
passenger's seat can only be adjusted if
the ignition key is in position I or II, or if the
engine is running.
90
Adjusting the seat
Seat adjustment controls 1, 2, 3, and 4 on the
side of the seat can be used to move the seat
to the position of your choice.
1. Move this section of the control up or
down to raise/lower the front section of
the seat cushion.
2. Move the control forward/rearward to
move the seat forward or rearward.
3. Move this section of the control up or
down to raise/lower the rear section of
the seat cushion.
4. Backrest tilt.
NOTE
The power seats have an overload protector
that activates if a seat is blocked by any
object. If this occurs, switch off the ignition
(key in position 0) and wait for approxi-
mately 20 seconds before operating the
seat again.
Emergency stop
If the seat inadvertently begins to move,
press any of the buttons to stop the seat.
Programming the seat memory, driver's
seat only (option)
Power seat memory buttons
Three different seating positions (and the
position of the door mirrors) can be stored in
the seat's memory. The memory buttons are
located on the outboard side of the driver's
seat (see the illustration above).
The following example explains how memory
button 1 can be programmed. Buttons 2 and
3 can be programmed in the same way.
To program (store) a seat position in memory
button 1:
1. Adjust the seat (and door mirrors) to the
desired position (see the instructions in
the center column).
Advertisement
Table of Contents
