Volvo C70 Owner's Manual page 76

(located on your sun visor), keeping the
HomeLink indicator light in view.
3. Using both hands, simultaneously press
and hold both the desired HomeLink
button and hand held transmitter but-
ton. DO NOT release until the HomeLink
indicator light flashes slowly and then
rapidly. When the indicator light flashes
rapidly, both buttons may be released.
(The rapid flashing indicates successful
training.)
NOTE
Some garage door openers may require you
to replace step 3 with the "cycling" proce-
dure noted in the "Programming the trans-
ceiver for the first time (Canadian
residents)" section.
4. Press and hold the trained HomeLink
button and observe the indicator light.
• If the indicator light is solid/continuous,
training is complete and your device
should activate when the HomeLink but-
ton is pressed and released.
• If the indicator light blinks rapidly for 2
seconds and then turns a solid/continuous
light, proceed with the following training
instructions for a rolling code device. A
second person may make the following
steps quicker and easier. Please use a
ladder or other device. Do not stand on
your vehicle to perform the next steps.
5. At the garage door opener receiver
(motorhead unit) in the garage, locate
the "learn" or "smart" button (usually
near where the hanging antenna wire is
attached to the unit). If there is difficulty
locating the training button, reference
the garage door opener's manual or
contact us toll-free 1-800-355-3515
(Internet: www.HomeLink.com).
6. Press and release the "learn" or "smart"
button (the name and color of the button
may vary by manufacturer).
NOTE
Once the button is pressed, there are 30
seconds in which to initiate the next step.
7. Return to the vehicle and firmly press
and hold the trained HomeLink button
for two seconds and release. Repeat the
"press/hold/release" sequence up to 3
times to complete the training process.
To train additional HomeLink buttons, begin
with step two.
02 Instruments and controls
HomeLink® Universal Transceiver (option)
Programming the transceiver for the
first time (Canadian residents)
1. For first time training, press and hold the
two outer HomeLink buttons releasing
only when the HomeLink indicator light
begins to flash after 20 seconds. (Do not
perform this step when training the addi-
tional HomeLink buttons.)
2. Position the hand-held transmitter 1-
3 inches (2.5-7.5 cm) away from the
HomeLink surface (located on your)
keeping the HomeLink indicator light in
view.
3. Using both hands, simultaneously press
and hold both the desired HomeLink
button and hand held transmitter but-
ton. During programming, your hand-
held transmitter may automatically stop
transmitting. Continue to press and hold
the desired HomeLink button while you
press and re-press ("cycle") your hand-
held transmitter every two seconds until
the frequency signal has been learned.
The indicator light will flash slowly and
then rapidly after several seconds upon
successful training. DO NOT release
until the HomeLink indicator light
flashes slowly and then rapidly. When
the indicator light flashes rapidly, both
buttons may be released. (The rapid
flashing indicates successful training.)
02
75