Table of Contents
Advertisement
Function Keys
When using the unit, you can assign certain functions
(recording, playback, etc.) to the function keys (F1 to
F12) at the top of a keyboard and perform these functions
with a single keystroke.
We recommend assigning frequently used functions
based on your working environment.
Tip
To perform controls for only Ch2 without the use of a
touch panel monitor, the Ch2 controls must be assigned to
function keys beforehand.
Using Function Keys
Tip
The function keys are enabled only when the hard
keyboard mode is enabled.
1
Press the MENU button.
The [MENU] screen appears.
2
Select [Settings], and press the ENTER button.
The [Settings] screen appears.
3
Select [System Admin Settings], and press the
ENTER button.
The [System Admin Settings] screen appears
4
Select [Device Settings], and press the ENTER
button.
The [Device Settings] screen appears.
5
Display the [Device 2] tab, and set [Keyboard Mode]
to [Hard Keyboard].
6
Select [Advanced] for [Keyboard Mode], and press
the ENTER button.
The [Function Key Setting] screen appears.
7
Select the check boxes of the necessary function keys,
select [Edit], and then press the ENTER button.
The [Edit] screen appears.
8
Select the functions to assign to the function keys
under [Function], select [Apply], and then press the
ENTER button.
The [Function Key Setting] screen appears again.
9
Select [Apply], and press the ENTER button.
The [Function Key Setting] screen closes, and the
[Device 2] tab appears again.
Factory Assigned Functions
The following functions are assigned to the function keys
under factory default conditions.
Function Keys
F1
F2
F3
F4
F5
F6
F7
F8
F9
F10
F11
F12
Tip
The following functions operate as follows.
• [Rec Prep / New Folder]: Display the [Recording
Preparation] screen. A new folder is created.
35
Function
Rec Prep / New Folder
Playback
Fast forward
Rewind
Stop
Pause
Record
Capture
Call list
Add to list
Set Chapter
Close Folder
Advertisement
Table of Contents
