Table of Contents
Advertisement
Parameter Function
Select speed dome connected channel.
Channel
There are two options: local/remote.
PTZ Type
Please select remote type if you are connecting to the network PTZ.
Select the corresponding dome protocol such as PELCOD.
Protocol
Set corresponding dome address. Default value is 1. Please note
Address
your setup here shall comply with your dome address; otherwise
you cannot control the speed dome.
Select the dome baud rate. Default setup is 9600.
Baud
Rate
Default setup is 8. Please set according to the speed dome dial switch
Data Bit
setup.
Default setup is 1. Please set according to the speed dome dial switch
Stop bit
setup.
Parity
Default setup is none. Please set according to the speed dome dial
switch setup.
5.6.5.5 Account
Note:
For the character in the following user name or the user group name, system max supports
6-digits. The space in the front or at the end of the string is null. The valid string includes:
character, number, and underline.
The user amount is 20 and the group amount is 8 when the device is shipped out of the
factory. The factory default setup includes two levels: user and admin. You can set the
corresponding group and then set the rights for the respective user in the specified groups.
User management adopts group/user modes. The user name and the group name shall be
unique. One user shall be included in only one group.
5.6.5.5.1
User name
In this interface you can add/remove user and modify user name. See Figure 5-54.
Add user: It is to add a name to group and set the user rights. See Figure 5-55.
There are three default administrator users: admin/888888 and hidden user "default".
Hidden user "default" is for system interior use only and can not be deleted. When there is no
Figure 5-54
158
Advertisement
Table of Contents
