i3TOUCH E1070T10 User Manual page 5

Table of Contents

Advertisement

13) Lightning
For added protection for this product during a lightning storm, or when it is left unattended and
unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable
system. This will prevent possible damage to the product due to lightning and power-line surges.
14) Power Lines
An outside antenna system should not be located in the vicinity of overhead power lines or other
electric light or power circuits, or where it can fall into such power lines or circuits. When installing
an outside antenna system, extreme care should be taken to avoid contact with such power lines or
circuits, as contact with them might be fatal.
15) Earthing the product
This product must be earthed properly to comply with the safety regulations in the country of use.
If you are unsure of these regulations, please consult a qualified electrician.
16) Servicing
Do not attempt to service this product yourself as opening or removing covers may expose you to
dangerous voltages or other hazards. Refer all servicing to qualified service personnel. If the Set
does not operate properly, switch it off and call your dealer.
17) Damage Requiring Service
Isolate this product from the mains supply and refer servicing to qualified service personnel under
the following conditions:
1. If the power-supply cord or plug is damaged.
2. If the glass front has been damaged.
3. If there is ingress of water between the glass and the LCD screen.
4. If the product does not operate normally by following the operating instructions. Adjust only
those controls that are covered by the operating instructions as an improper adjustment of other
controls may result in damage and will often require extensive work by a qualified technician to
restore the product to its normal operation.
5. If the product has been dropped or the cabinet has been damaged.
6. If the product exhibits a distinct change in performance.
18) Safety Check
Upon completion of any service or repairs to this product, ask the service technician to perform
safety checks to determine that the product is in proper operating condition and the front seal is
intact.
19) Mounting
The product should be mounted on a wall only as recommended in the instructions.
20) Power
This set operates on an AC supply; the voltage is as indicated on the label on the Manual. This
appliance must be earthed at all times through the chassis as well as through the power lead.
21) Location
Do not install on an unstable location with support area smaller than the DID SET.
Please secure enough space for safety use.
Version 1.0
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

E 1086 t10 4k

Table of Contents