Freestanding Installation - Rinnai DEPH-10DTW Operation & Installation Manual

INSTALLATION

FREESTANDING INSTALLATION

A
B
A B
1. Be sure heater is unplugged before attempting to install the castor components.
2. Assemble the 2 castors
3. Place the heater in an 'upside down' position with the back of the heater facing you.
4. Remove the two of the pre-installed case screws
5. With the front end of the castor assembly pointed towards the front of the heater, align the two holes
castor foot with the two holes in the base the appliance
6. Repeat steps 4 and 5 to install the second castor assembly.
7. Rotate the heater back to the upright position and remove
the cable tie from the flexible cord, then insert the power
plug of the heater directly into a power socket outlet.
8. The heater is now ready to be used as a free standing appliance. Refer to the operation section at the front of
this manual for full instructions on how to use the heater.
Rinnai
A B
Front of
castor
assembly
to the each castor foot
A
C
D
E
by pushing the metal shaft fully home.
B
from the base of the appliance
C
and fix in place with the screws
D
DO NOT bundle or coil the flexible cord
to reduce it's length as overheating and
IMPORTANT
subsequent fire hazard could result.
14
Back of
heater
.
D
in the
E
removed in step 4.
C
DEPH_OIM