Sony TAV-L1 Service Manual page 9

PRECAUTION WHEN REMOVING GOOD OPTICAL PICK-UP BLOCK
CAUTION
Be sure to bridge here, and then disconnect the
wire (flat type) (24 core).
(optical pick-up block will be destroyed without bridging)
On the contrary at the installation, connect the
wire (flat type) (24 core) first, and then remove the bridge.
Note: For a soldering iron, use the one with a ground wire.
(Refer to DISASSEMBLY 3-12. OPTICAL PICK-UP BLOCK (KHM-310CAB or KHM-313CAB))
optical pick-up block
DVD MECHANISM DECK (CDM86-DVBU101), DMB13 BOARD AND VIDEO-UC BOARD
SERVICE POSITION
Note: Remove the DMB13 board, VIDEO-UC board and DVD mechanism deck
insulating sheet
VIDEO-UC board
DMB13 board
DVD mechanism deck
(CDM86-DVBU101)
from the set once, and then connect them as shown above.
wire (flat type) (24 core)
TAV-L1
9