Sony TAV-L1 Service Manual page 11

SUB BOARD SERVICE POSITION
Note: Rotate the belt in the arrow A direction until
the CONNECT-UC board can be seen
best to lower the DVD block.
DVD block
A
CONNECT-UC board
(CN1301)
CONNECT-UC board
CONNECT-UC board
(CN1305)
belt
Connect the extension jig (J-2501-288-A) to the
SUB board (CN918) and CONNECT-UC board (CN1301).
SUB board (CN918)
Connect the extension jig (J-2501-287-A) to the
SUB board (CN909) and CONNECT-UC board (CN1305).
CN1301
Note: Though the connector for jig connection
is located where it may hard to make
an access to it as shown below,
perform work in this state.
TAV-L1
SUB board (CN909)
SUB board
CN1305
11