TEC SL-5900 Series Programming Manual page 63

EM3-31005
[P2-41 Zero lamp ON condition, Random item PLU, Selection of label, Fix price function, Label
auto print, etc.
r+yl&
w5 w4 w3 w2 UP5 UP4 UP3 UP2
L
I Zero lamp ON condition
UP3 UP2 Condition Remarks
0 0 Lit when GROSS = 0 f ll4d
for
CA
0 1
Lii when GROSS = Od
1 0 Lit when Net = Od
1 1 No zero lamp for US
Any combination of bits other than the above is prohibited.
Random Item PLU
0: Not available
1: Available
Available/Not available
Select the using label length
0: (POS label)
1: (Non-POS label)
Select the label sensitivity
0: High-sensitivity (LA-l 20 or equivalent)
1: Low-sensitivity (R-4K or equivalent)
FIX price function ( * ) Available/Not available
Indicates whether the center select position of Mode SW (2) is to be
as the fix price function. (Refer to NOTE)
0: Not available
1: Available
NOTE:
In the CA version, it must be set to "0" according to the
W/M specification.
Label auto print Available/Not available
If there is a change in weight when the label has been issued, the taking
of that label will cause the next label to be automatically printed or not,
depending on the setting of this bit.
0: Not available
1:
Available
Issuing the BY COUNT label with Mode SW (1) set "AUTO."
0: One BY COUNT label is issued.
1:
BY COUNT label is issued in succession after peeling it.
NOTE: The value with asterisk ( * ) cannot be changed after HAM Clear except for US and MX types.
- 60 -