EM3-31005
8. SWITCH AND KEY FUNCTIONS IN INITIAL SETTING
8.1.
Initial Switch
m
Initial Switch
8.2.
Operation
Keys
Fig. 8-2.
NOTE: a,@,,
and @I in Fig. 8-2
are the symbols showing
the key position.
When this switch is depressed
after the power is turned
on, the scale switches the mode to Initial Setting.
When this switch is depressed
again after Initial Setting,
the scale is ready for normal use.
I
Power ON
4
Press
Initial SW.
4
Initial setting
mode
Press
Initial SW.
4
Turn the control lock to
"REG" position.
4
Scale is ready for normal
use.
Key
Function
To change the initial setting modes:
P6 f-
P5
f-
P4
1) To eject to a new page in "PO" mode.
2) To register the data in the NOV RAM in
"Pl" mode and also used to eject to a
new page.
cl
1) To eject to a new page in "Pl" mode.
C
2)
To register the data in the NOV RAM in
"P2" mode and also used to eject to a
new page.
To return the weight dispaly to zero in
setting span data in "Pl" mode.
To start the CMT test
Message Display test
(P4), RAM check (P5),
(P6), and TMCC test
Numeric
keys
1) To enter data in "Pl"
mode.
2) To turn on or off a bit in "P2" mode.
- 43 -