Important Notes; Customer Support; Installing The Usb Driver; Prior To Installation - Ricoh RDC-6000 Installation Manual

2. Important notes

These instructions will guide you through the process of installing the RDC-6000 USB driver and utility
software on your Windows XP computer. Be sure to read, understand, and observe all precautions and
requirements prior to attempting these procedures. If you feel you need assistance, please contact our
customer support network at the URL listed in the Customer support section below.
• Operating System: Windows XP (operation not guaranteed with other operating systems)
• Memory: 128MB or more (256MB or more is recommended)
• Connection cable: Use the dedicated cable included in the package
• Retrofit USB ports added by using an expansion feature (such as PCI bus) cannot be supported.
• Driver may fail to operate correctly when used with a USB hub or other USB devices.

3. Customer support

The following URLs may be useful if you need support during the installation process.
Download Windows XP-compatible software
http://www.ricoh.co.jp/r_dc/dc/notices/xp-dl.html
Contact Ricoh's customer support team
http://www.ricoh.co.jp/r_dc/dc/support/inquiry.html

4. Installing the USB driver

Note: The authority to install the driver to Windows XP is limited to users with administrator accounts. Users
who cannot log on as administrators will not be able to install this driver.
I. Prior to installation
(1) Download the latest RDC-6000 software at http://www.ricoh.co.jp/r_dc/dc/notices/xp-dl.html. Be sure to
note the location where you save the downloaded file(s). You will need that information during the
installation. Also, be sure to save the downloaded files to your computer's hard drive.
(2) Save any important data you may be using and then quit all running applications.
(3) Disconnect any other USB or Plug & Play devices.
II. Installation procedure
(1) Switch on the computer and start Windows.
(2) Connect RDC-6000 to your PC via USB cable (make sure
camera is set to PC connection mode). Turn camera on.
(3) When the Found New Hardware Wizard appears, select
"Install from a list or specific location (Advanced)" and click
Next to continue. (See Figure 1.)
(4) The next window prompts you to specify the location of the
driver. Browse to the folder where it is saved and then click
Next to continue. (See Figure 2.)
4 - RDC-6000 Windows XP Installation Guide
Figure 1: Found New Hardware Wizard